top of page
Make Your Own
Fidget Spinner
July 10-14 12:00 pm-3:00 pm
Single Session Fee: $70
Instructor: Mr. Matteis
Anyone can buy a fidget spinner, but imagine if you made your own? We will design and print the base of the spinner on a 3-D printer. Students will make precise measurements and install skateboard wheel bearings to create these assemblies.
Requirements:
This session will only be open to the first 13 students due to the availability of equipment and must have all 13 to go. There is a $10 supply fee included in the $70 cost.
Build your fidget spinner from the ground up and then print it on a 3D printer.
Fidget Spinner
bottom of page